Nxg-technology NX-RF200 Manuel d'utilisateur télécharger pdf (Page 9)

Front Blaster Overload

A few models of audio/video components can be overloaded by the Front

Blaster. If you are having intermittent or inconsistent results with a particu-

lar component, try repositioning the NX-RF200 and facing the Front Blaster

in a different direction. If this improves the situation but is impractical, it

may be necessary to utilize the self-adhesive flashers only and follow the

steps below to Disable the Front Blaster. This will limit the number of com-

ponents your can control to four. If you have more than four components

you can purchase an additional NX-RF200.

Disabling the Front Blaster - Step by Step via PC

Note: If you are programming a NXG NX-RM “addressable” remote con-

trol that sets up without a PC, refer to the owners manual to disable the

Front Blaster.

Open the PC software, then plug the NX-RM PC programmable remote

control into the PC. Open your saved configuration and follow these

steps to turn off the front blaster:

Step 1 - Open the RF Setup Window

The RF Setup window opens after selecting RF Control or Settings from the

Program Menu of most NX-RM editors or from the Main Menu of the NX-

RF200.

Step 2 - Setup the Receiver

Extend the RF Setup window by clicking on the

Receivers button.

Step 3 - Turn off the Front Blaster

Click on the cell in the IR LED OUT-

PUT/IR BLASTER column. A list box

will appear. Select OFF from the list.

Next, click on Close to apply your change.

NX-RF200 Base Station

NX-RF200_Manual.qxd 10/27/08 12:48 PM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Nxg-technology NX-RF200 Manuel d'utilisateur Page 9